Hudson-robotics Dried Blood Spot Processor Instrukcja Użytkownika Pobierz pdf (Strona 9)

DBS Processor Page 7

SECTION III

Machine Operation

A. Start-Up

1. Cable Connections

Computer - connect the computer power cable.

Mouse - connect the mouse cable to the computer backpanel.

Keyboard – connect the keyboard cable the the PS/2 port on the handheld scanner

Computer Monitor (optional) - connect the monitor communications cable to the

computer; plug monitor to wall outlet.

USB to RS232 Converter (optional) – connect the USB converter to the computer

using the supplied USB cable.

Footswitch - connect the 4 pin plug on the footswitch cable to the 4 pin receptacle

marked “Footswitch” on the processor back panel.

Stationary Barcode - using the supplied serial cable, connect the 9-pin female to an

RS232 port on the computer or the optional USB to RS232 converter.

Hand-Held Barcode - using the supplied barcode reader cable, connect one end of

the cable to the computer's keyboard input port and plug the keyboard into the other

end.

Controller - using the supplied serial cable, connect the 9-pin female to an RS232

port on the computer or the optional USB to RS232 converter.

AC Power - using the 3 conductor detachable line cord, connect the female end to the

connector marked “AC Power” on the processor back panel.

Pneumatic - using the ¼-inch quick-connect fitting on the processor back panel, run

a flexible ¼-inch air line from a source of clean, dry air rated at 80-100 psi. This air

is required to power the punch.

2. Power-Up The Processor

Step 1: Connect all cables as outlined in Section III.A.1.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Brak uwag

Hudson-robotics Dried Blood Spot Processor Instrukcja Użytkownika Strona 9