Hudson-robotics Bar Code Print and Apply Instrukcja Użytkownika Strona 16
- Strona / 33
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Print and Apply User Manual Hudson Robotics, Inc.
14
C. Hardware Setup
Prior to Label Setup, the hardware must be configured to pick up labels properly. The
apply head can be controlled from the label retrieval or apply head setup screens.
1. Move the apply head out of the way of the air blast.
2. Press the Feed button on the front of the printer to advance one label to
the tear off position.
3. The label should stop right at the edge of the strip bar as seen below.
4. If the label is not in the correct location, it will have to be adjusted
through the printer’s front panel.
5. To get into the submenus, press the (Setup-Exit) button on the front
panel of the printer.
Feed Button
Air Blast
Strip Bar
- Hudson Print and Apply 1
- Table of Contents 2
- ! CAUTION 3
- CHAPTER 1 - Overview 4
- CHAPTER 2 – Installation 5
- Printer Leveling Feet 7
- NOTE: 11
- Print head arm 12
- Pause Button 13
- Build up after 13
- CHAPTER 3 - Calibration 14
- B. Setup Screen 15
- C. Hardware Setup 16
- D. Label Setup 18
- 0.030” Gap 19
- Front Edge 19
- Front edge 19
- E. Apply Nest Setup 20
- CHAPTER 4 – Operation 22
- A. Creating Labels 22
- C. SoftLinx Operation 28
- CHAPTER 5 - Maintenance 30
- A. Warranty 31
- B. Service Agreements 32
Powiązane produkty i podręczniki dla Narzędzia Hudson-robotics Bar Code Print and Apply
(54 strony)Fujitsu Stylistic ST4000 Series Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Spiele Fujitsu Stylistic ST4000 Series.
Wir stellen 1 PDF-Handbücher Fujitsu Stylistic ST4000 Series zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Komentarze do niniejszej Instrukcji